NATURAL EARTH SEALANTS

Rubberising of work surfaces

 

Preparation of surface:

• Areas to be treated should be free from all dirt, oil, grease and loose particles. Remove excessive grease efficiently with a degreasing agent.

• Clean with steel brush and 40 grid sandpaper

• If rust occurs apply B-treat until rusted area is saturated.

• If metal is totally rusted away a membrane can be used to fill up. Load bearing qualities may be affected.

 

 Note:

• B-Earth Products must be stirred well before use.

• Products can be applied by paintbrush, paint roller or spray gun

• Where artwork is to be painted on B-rubber, apply B-paint before B-varnish.

• White B-rubber always to be painted with B-paint White as final coat.

• If rubber is applied to a bakkie or truck, rubber should be applied  5-6mm thick

 

Application:

• Apply one (1) coat B-bond as minimum. Allow to dry.

• Where B-bond don’t stick to surface, scrub or sand B-bond into substrate with wire brush or 40 grid sandpaper.

• If rust occurs apply B-treat 2 coats

• Apply B-rubber of colour choice. Allow for four coats by brush in 90 degree angles towards each other. Final coat can be sprayed on by sandblast gun. B-varnish can be used for glossy finish.

 

Cleaning:

• Products are water based

• Clean all equipment thoroughly with water immediately after use.